Best Modules will be closed from Apr. 3nd to Apr. 6th in observance of Tomb Sweeping Day.
Please be informed that any orders placed after 15:00 PM Apr. 1st (Taiwan time, UTC+8) will be processed on Apr. 7th.

Shopping Cart 0
US$0.00

DALI Debug Board ESK-DALI-DT8TC00

US$22.50
In stock
Quantity
12 pieces
Product ID
ESK-DALI-DT8TC00

The product is a debug board designed for DALI LED driver control modules. It includes a DALI module slot that can directly connect to the modules. It is highly convenient to use this product alongside the DALI host simulator board, ESK-DALI-H00, to evaluate the functionality of the modules.

Follow Us for More Updates!
HARDWARE OVERVIEW
Power supply
  1. UART/Power Input Interface: supplies 12V power from the host simulator board, ESK-DALI-H00
  2. Pull-out VCC Pin of DALI Module: 7~30V
Please note that these two power supply methods cannot be used simultaneously.
Programming interface

The interface is designed for on-chip debugging and in-circuit programming (ICP).
The BM82D8021-1 and BM82D8022-1 support on-chip debugging. However, the MCU used in the BM82D8011-1 does not have the OCDSDA and OCDSCK pins, so it does not support on-chip debugging.

Debugging

  1. BM82D8021-1: e-LinkPro2/e-Link and HT-IDE3000 software
  2. BM82D8022-1: e-Link32 Pro and Keil uVision5 software

In-circuit programming

  1. BM82D8021-1 & BM82D8021-1: e-LinkPro2/e-Link and HOPE3000 for e-Link software
  2. BM82D8022-1: e-Link32 Pro and e-Link32 Pro ICP Tool software
Iset switch

The PWM output level (brightness) is controlled by the external DIP switch and resistors connected to the Iset pin.

Please note: a power cycle is required after adjusting the switch.
Fault detection switch

It is used to simulate the fault signal detected from the DALI LED driver control module.
The switch can simulate three different states:

  1. OPEN: simulate open-circuit fault signals
  2. SHORT: simulate short-circuit fault signals
  3. NORMAL: normal state
Cascade

Steps for cascading DALI LED driver control modules:

  1. Connecting the UART/power output interface of the host simulator board ESK-DALI-H00 to the UART/power input interface of the product.
  2. Modules can be cascaded through both the DALI interface and the power output/input interface of the product.

⬥Refer to the diagram in the ‘Wiring’ section below for more information.

WIRING

You only need one ESK-DALI-H00 to cascade multiple DALI LED driver control modules.
Please refer to the following wiring diagram, where we cascade 3 modules through the product, and power is supplied from the DC jack.

PRODUCT INFORMATION
  1. Dimension: 95 x 75 x 18mm
  2. Net weight: 53.6g
  3. Product includes: ESK-DALI-H00 x1| Nylon post x4 | 4-pin cable x1
RESOURCES
  1. Development platform: DALI Workshop, including user's guide, software.
More Information
HS Code (reference) 8504.40.20.00-3
Youtube
Contact Us